Giant 1-Feb Manual de usuario descargar pdf (Pagina 14)

Connecting to the Console Port (FastHub 400M Models)

FastHub 400 10/100 Series Installation and Configuration Guide

2-14

Connecting to the Console Port (FastHub 400M Models)

To connect the RJ-45 console port of a FastHub 400M model to a management station or

modem, you must use the supplied RJ-45-to-RJ-45 rollover console cable and the

appropriate adapter and follow these steps.

Note The rollover console cable and a RJ-45-to-DB-9 female DTE adapter are supplied

with the hub. If your management station requires a different adapter—such as a

RJ-45-to-DB-25 female DTE or RJ-45-to-DB-25 male DCE adapter—you must provide it.

Step 1 Conﬁgure the hub console port settings to match the management station or

modem. These are the default settings of the console port:

• 9600 baud

• 8 data bits

• 1 stop bit

• No parity

• No ﬂow control

You can change the console port characteristics of the hub from the web-based

System Conﬁguration Page (see the “Changing the System Conﬁguration”

section on page 3-40) or by using the terminal command from the CLI.

Note Make sure the settings of the console port and the management station or

the modem match.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

Sin comentarios

Giant 1-Feb Manual de usuario Pagina 14